EasyManuals Logo

Precor ENERGY SERIES User Manual

Precor ENERGY SERIES
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
© 2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law 5Page 5 of 54
About This Document
This document contains information required to perform the majority of troubleshooting, and
replacement procedures required to repair and maintain this product.
Warning:
This service manual is for use by Precor trained service providers only. If you are not a
Precor Trained Servicer, you should not attempt to service any Precor products. Call your
dealer for service.
This document contains general product information, software diagnostic procedures (when
available), preventative maintenance procedures, inspection and adjustment procedures,
troubleshooting procedures, replacement procedures and electrical block and wiring diagrams.
Manual Part Number 20081-121 rev 01
Contact
Precor Incorporated
20031 142
nd
Ave. NE
P.O.Box 7202
Woodinville, WA. 98072-4002
1-800-347-4404
General Information
Lubricants
Do not apply any lubricants to the deck and belt. Do not use Wax Blast, silicon sprays, or other applied
lubricants. The use of these lubricants will quickly degrade the low-friction surface of the deck.
Do not use petroleum based lubricants on mechanical components such as the lift, as this may result in
degradation of nylon gearing mechanisms. Use only synthetic lubricants such as "Super Lube with
Teflon" or "Mobile One Synthetic" grease (RED).
NOTE
Use of unapproved lubricants, cleaners, or solvents may void the treadmill warranty
Power Requirements
Input Power Requirements
U.S. 120 V Units: 120v, 60 Hz, 15A Dedicated branch circuit
.Facility Input Power Requirements
Each treadmill must be connected to a dedicated, grounded circuit. A 15 amp dedicated circuit is
required, but a 20 amp dedicated circuit is recommended. The power outlet must have the same
configuration as the plug. No adapter should be used with this product.
Grounding Instructions
The unit is equipped with a power cord having an equipment-grounding conductor and a
grounding plug. The plug must be inserted into an outlet that is properly installed and grounded in
accordance with all local codes and ordinances. Failure to properly ground the treadmill could void
the Precor Limited Warranty.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Precor ENERGY SERIES and is the answer not in the manual?

Precor ENERGY SERIES Specifications

General IconGeneral
BrandPrecor
ModelENERGY SERIES
CategoryTreadmill
LanguageEnglish

Related product manuals