P31 Console Installation Guide
WARNING
Before you connect any cables to the console, make sure that the equipment is not connected to any external power source.
For more equipment information and troubleshooting, visit us at www.precor.com.
Earlier in the installation of your console, you threaded the necessary cables through the frame of the base equipment and out the opening in the console
mount. Gently pull as much loose cable as you can through the opening in the middle of the console mount before attaching the console.
NOTE
If you are also installing an additional component, such as a PVS or a wireless audio receiver, review its instructions to coordinate both
installations.
Begin assembly
To begin assembly:
1. Set the console on the rectangular hook at the bottom of the console mount (see Figure 1).
2. Tilt the console forward and hold it in place.
NOTE
Precor recommends that you have an assistant hold the console securely while you route the cables.
Figure 1
3. Pass all cables through the rectangular opening just above the console mount hook (Figure 2).
NOTE
DO NOT attempt to route any cables through other openings on the mount.
Figure 2
To Next Page
Need help?
General
