EasyManua.ls Logo

Precor RBK 815 - Page 11

Precor RBK 815
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RBK 815 Recumbent Cycle
Page 11
11. U-BOOT SW display. This display the installed version of upper boot software.
The boot software is used to upload new software into the upper display PCA.
12. Press the OK key. The software part number will be displayed as XXXXX-XXX.
13. Press the CLEAR key to exit the U-Boot SW display.
14. U-BASE SW display. This display the installed version of upper PCA software.
15. Press the OK key. The software part number will be displayed as XXXXX-XXX.
16. Press the CLEAR key to exit the U-Base SW display.
17. LOWER SW display. This display the installed version of lower PCA software.
18. Press the OK key. The software part number will be displayed as XXXXX-XXX.
19. Press the CLEAR key to exit the lower SW display.
20. SER. NUMBER display. Press the OK key.
21. The bicycle’s serial number will be displayed. The serial number may be incorrect
or not displayed if the upper PCA has been replaced.
22. Press the CLEAR key to exit the serial number display.
23. USAGE LOG display. Press the OK key.
24. Use the p,q keys to move through the list of programs. A message will scroll
describing the program, the number of times and the number of minutes the
program was used.
25. Press the CLEAR key to exit the usage log display.
26. ERROR LOG display. Press the OK key, the quantity of errors in the log will be
displayed.
27. Press the OK key, the most recent error will be displayed first.
28. Use the p,q keys to move through the list of errors. The error messages will list the
error name, the odometer reading when the error occurred, the hour meter when
the error occurred.
29. If you wish to clear the error log, press and hold the QUICK START key. The
message HOLD TO CLEAR ERRORS will be displayed. The error log will be
cleared when the message NO ERRORS is displayed.
30. Press the RESET key to exit the information display.
31. Please note that the ERROR LOG may also be accessed at any time by pressing
and holding the RESET key for four seconds. If the error log does not contain any
errors, the message STUCK KEY will be displayed.

Other manuals for Precor RBK 815

Related product manuals