RBK 815 Recumbent Cycle
Page 43
Procedure 7.7 - Replacing the Idler Pulley
1. Remove the top, rear, left and right covers per procedure 7.1.
2. Loosen, but do not remove the idler pulley mounting nut.
3. Remove tension from the primary belt by turning the primary belt tension
adjustment bolt counter-clockwise. See Diagram 7.4.
4. Remove the primary belt.
5. Remove the idler pulley by removing the idler pulley mounting nut. Discard the
idler pulley.
6. Mount the replacement idler pulley using the nut removed in step 5. The idler
pulley mounting nut should only be finger tight at this time.
7. Replace the primary belt and tension the primary belt per Procedure 5.1.
8. Torque the idler pulley mounting nut to 120 inch pounds (10 foot pounds).
9. Replace the covers per Procedure 7.1.
To Next Page
Loading...
