RBK 815 Recumbent Cycle
Page 38
8. Thread the crankarm mounting bolt, removed in step 2 into the crankarm until it
is finger tight. Torque the crankarm bolt to 360 inch pounds (30 foot pounds).
9. The right hand pedal threads onto the crankarm in a normal (clockwise) direction,
the left hand crankarm is reverse (counter-clockwise) threaded.
10. Install the pedal, removed in step 1, on the replacement crankarm and torque it to
800 inch pounds (67 foot pounds).
11. Pedal the bike for 1 minute and then re-torque left and right crankarms to the
specification indicated in steps 8 and 9.
To Next Page
Loading...
