Chapter 2
Assembling the
StretchTrainer
Unpacking the StretchTrainer
Carefully unpack the parts and lay them on the floor near the
location where you plan to assemble the equipment.
If any items are missing, contact the dealer from whom you
purchased the StretchTrainer or use the Precor web site at
www.precor.com to find the dealer nearest you.
Important: Be aware that the lubrication on the fasteners can
stain carpeting and clothing. Precor recommends that you set the
fasteners on a piece of cardboard packaging during assembly.
The following pieces of hardware are shipped with your
StretchTrainer.
Seat frame
Padded seat (includes 4 bolts and 4 washers)
Knee pad (includes 4 bolts and 4 washers)
Two base rails (includes one bolt and washer per rail)
Handlebar (includes wrist straps)
Instructional placard
StretchTrainer documentation including warranty
Two rear level adjusters
Seat bumper
Alignment bracket
Seat bracket
Hardware kit
– 3 mm hex wrench
– 6 mm hex wrench
To Next Page
Loading...
Need help?
General
