Precor Vitality Series - Safety Approval; Obtaining Service

Tighten all frame mounting hardware
Figure 7
1. Check that the weight tower and seat frame are sitting evenly on the floor.
2. On the weight tower, tighten the mounting hardware at the base support, then at the cross
support.
3. On the seat frame, tighten the mounting hardware at the base support, then at the cross sup-
port.
Adjust cable tension
Figure 8
Figure 9: Misaligned
Figure 10: Aligned
Figure 11
1. Be sure that at least seven (7) turns/threads are engaged into the cable connection on the
floating pulley, and that the jam nut is tightened securely.
2. Place the weight selection pin in the top weight.
3. Screw the cable bolt into the selector stem until the cable meets the following requirements:
— At least seven (7) turns/threads (minimum) of the cable bolt into the weight selector stem.
— A maximum of 1-1/8 inch (29 mm) between the bottom of the cable bolt head and the
bottom of the flange lock nut.
— No excess slack remains.
— The top weight begins to separate from the second weight.
— The cable is just loose enough to permit insertion of the selector in into each of the weight
plates.
4. Hold the weight tower straight while tightening the locking jam nut against the selector stem.
If you do not hold the weight tower straight, it can twist (see Figure 9).
5. Once tightened, verify alignment between the selector and the add-on weight.
6. Check the adjustment by inserting the weight pin into every weight plate hole. The weight pin
should slide easily in and out of each weight plate.
Attach the pads
Figure 12
1. Attach the seat pad to the seat mounting bracket using:
Note: The wide end of the seat pad should be facing the foot plate.
4 – M10 x 30 mm hex bolts
4 – 11 mm flat washers
2. Attach the back pad to the back pad frame using:
Note: The narrow end of the back pad should face upward.
2 – M10 x 30 mm hex bolts
1 – M10 x 75 mm hex bolt
3 – 11 mm flat washers
3. Attach the rubber foot pad to the foot plate by positioning the top edge of the rubber foot
pad over the lip of the foot plate, and pressing the side edges of the foot pad over the sides of
the foot plate. Press the bottom edge of the foot pad over the bottom side of the footplate.
©2021 Precor Incorporated | VSL Leg Press/Calf Extension| Assembly Guide | P/N CWR107777-102 ENU 31 July 2021 | 4