Page 13For technical questions, please call 1-888-866-5797.ITEM 62201
SAFETYSETUPOPERATIONMAINTENANCE
Starting the Engine
Before Starting the Engine
a. Inspect the equipment and engine.
b. Fill the engine with the proper amount and type of both unleaded gasoline and oil.
c. TURN ON WATER SUPPLY, REMOVE NOZZLE, POINT WAND IN SAFE DIRECTION, AND HOLD
DOWN TRIGGER UNTIL ALL AIR IS RELEASED FROM THE SYSTEM, AT LEAST 30 SECONDS.
Then release the Trigger, lock it in the safety position and replace Nozzle before starting engine.
Manual Start
1. To start a cold engine, move the Choke to the
START position.
To restart a warm engine, leave the Choke in the
RUN position.
2. Push the Engine Switch to the ON position.
3. Grip the Starter Handle of the Engine loosely
and pull it slowly two times to allow the gasoline
to flow into the Engine’s carburetor. Then pull
the Starter Handle gently until resistance is
felt. Allow Cable to retract fully and then pull
it quickly. Repeat until the engine starts.
Note: Do not let the Starter Handle snap back
against the engine. Hold it as it recoils so it
doesn't hit the engine.
4. Allow the Engine to run for several
seconds. Then, if the Choke lever is in
the START position, move the Choke
Lever very slowly to its RUN position.
Note: Moving the Choke Lever too
fast could stall the engine.
1
START RUN
2
ON
3
START RUN
4
To Next Page
Loading...
