5
www.pregis.com 38-OM225-1
Specification
Installation
Specification and Installation
The machine should be positioned in the packing area allowing ample
space for loading the rolls of paper.
Do not allow the mains cable or footswitch cable to become damaged.
Ensure the mains supply cable is routed safely to prevent trip hazards.
Do not attempt to wheel the machine over uneven surfaces or at a speed
greater than a slow walk.
Dimensions (machine) 1170mm (L) x 775 (W) x 545 (H)
Dimensions (frame) 950mm (L) x 840 (W) x 885 (H)
Weight (machine) 124kg
Weight (frame) 24kg
Voltage 230V (±10%), 50Hz
Max Power 400W
Machine Fuse 6.3A
The machine is top heavy when mounted on the frame.
Temperature Min 5°C.
Humidity 10 to 90% RH.
Vibration
Do not install the Machine in an area where it is likely to be
subject to constant vibration.
Shock Do not drop the Machine or expose it to sudden shock.
Atmospheric
pollution
Do not install the Machine in an area that is subject to water
hazards, condensation, excessive dust or other atmospheric
contaminants.
Location It is important that the supporting floor is flat and level.
Lifting/Transporting Instructions
The machine must be securely strapped to a pallet for transporting safely.
The machine and frame weigh 148kg.
Connections
The machine must be connected to a 230V, 50Hz, 1-phase electrical supply.
THE MACHINE MUST BE EARTHED.
No other services are required. Maximum power consumption is 400W.
To Next Page
Loading...
