MAX PRO 18
©
Operator Manual
Original Printed in English
JOB SETUP SCREEN - BAG OPENING
Any changes made to this screen requires operator to press ‘Load Job’ button.
JAW PASS-THRU
Pass-Thru: Sets Pass-thru, will change (move) once job is loaded.
LOW PRESSURE AIR - Press box in middle to set timeout for LPA at end of cycle to hold bag open.
Always OFF: Always OFF
Always ON: Always ON
HIGH PRESSURE AIR
HP Air Dwell: Sets the length of time, in seconds, the High Pressure Air blasts.
VACUUM
Vacuum Dwell: Sets the length of time, in seconds, that Vacuum creates suction.
SCREEN NAVIGATION
SECTION 2 - CONTROLS
2-7
To Next Page
Loading...
