Premier WP-5 - Final Filter and System Startup

Page 11
Thread the larger (3/8”) white plastic connector into the inlet end
of the fi nal fi lter (fl ow arrow on fi lter points away from the 3/8”
connector - see picture).
Step 23 Thread the smaller (1/4”) white plastic connector into the outlet
end of the Final Filter and tighten (fl ow arrow on fi lter points to the
1/4” connector - see picture).
Step 24
Insert the 1/4” blue tube attached to the faucet into the outlet of the fi lter and tighten plastic
nut securely. The fl ow arrow should be pointing toward the faucet. Insert the 3/8” blue tube
attached to the module into the 3/8” inlet white connector on the in-line Final Filter. Tighten
the white compression nuts with an adjustable wrench.
Step 25
Remove the seal caps from both ends of the fi nal fi lter. Step 22
Do not overtighten these connectors as it may damage them
or the fi nal fi lter.
Note:
Final Polishing Filter Installation
Flow
1/4”
3/8”
A connection to a refrigerator / ice maker may be tee’d into this blue tube and should
be spliced in between the fi nal fi lter and the RO faucet.
Premier offers an ice maker install kit part # 500010 (See Page 22).
Note: