EasyManua.ls Logo

Premier WP-5 - Start up Instructions

Premier WP-5
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 12
Register by phone, fax, mail or internet. Premier uses this information only to provide you
with a lter change reminder service. Pre- lters should be changed every 6 months and the
nal in-line lter annually. You may register your system via our web site at
www.premierh2o.com or call 1-800-752-5582 (within USA only) / FAX#: 450-675-7995.
For Warranty card Please see page 25-26.
Don’t Forget To Register!
Start up Instructions
If you have connected your RO system to a refrigerator / ice maker, make sure the ice maker is
off (do not allow water to ow to the ice maker) until ushing (Step 4) is complete and the tank
has been allowed to ll completely. Connection from the RO to the ice maker system should
have an in-line valve installed before the ice maker so it can easily be closed to prevent water
owing to the ice maker during start up and periodic maintenance. Your storage tank must be
allowed to ll up fully in order for the ice maker system to work properly.
After the storage tank has lled (the water trickling has stopped), open the RO Faucet to
ush the tank completely. You will know that the tank is empty when the ow rate from the
RO faucet is down to a trickle. Repeat this step two more times. The fourth tank can be
used for drinking.
Open the RO faucet and leave it open until water begins to trickle out (this may take a few
minutes and the water will come out slowly).
Step 4
Turn on the incoming cold water at the angle stop valve and the
Adapt-a-Valve. Check the system for leaks and tighten any ttings
as necessary. (Check frequently over the next 24 hours to ensure
no leaks are present).
Step 3
Step 2
Note:
Step 1
Close the RO faucet allowing the storage tank to ll with water. It may take 3 to 6 hours to
ll the tank completely depending on the production capability of the membrane, local water
temperature and water pressure.
Flushing of the tank 3 times is only necessary during the initial startup and after replacing the
membrane.
During the ll period you may hear water trickling which is a normal occurrence.
Note:
Note:
Congratulations!
You have completed the installation of your new Reverse Osmosis system.
Please Follow the Startup Instructions.
The ushing process should take about a day to complete.
ON

Related product manuals