请注意,你的耳机的响度会因其设计和输入阻抗的不同而不同。
HP4
的输出阻抗是
51Ω
(欧姆),它与专业和消费类耳机都能正常
工作,但音量会因你使用哪种类型的耳机而不同。输入阻抗较低的
耳机一般会比阻抗较高的耳机声音大。
(
在这种情况下,更大的声音
并不意味着更好!)大多数专业耳机的阻抗在
150Ω
和
600Ω
之间。
用于
CD
机和类似设备的消费者耳机通常有
8Ω
至
32Ω
的阻抗。阻抗
在
8Ω
和
32Ω
之间。广播用耳机是专门的,你不太可能用
HP4
来使
用它们。
Mono button. When you press the Mono button,
each input will be summed together on each
output. For example, if you plug a CD player
into the left input, and press the Mono button,
the signal from the left input will be present in
the left and right headphone channels and in
the master output. When the Mono button is
not depressed, the left and right outputs will
carry the left- and right-channel signals,
respectively.
Mono button. 当你按下单声道按钮时,每个
输入都会在每个输出上被加起来。例如,如果
你把CD机插在左边的输入上,然后按下单声
道按钮,左边输入的信号将出现在左边和右边
的耳机通道和主输出中。当 Mono 按钮没有
被按下时,左和右输出将分别携带左和右声道
的信号。
Monitor Level. The Monitor Level knob
controls the volume of the rear-panel
Monitor Level. 这个旋钮控制后面板输出的音
量。
Monitor Mute. The Monitor Mute button
mutes the main rear-panel outputs, which is
handy when you only want to use the front-
panel headphone outputs. This is especially
helpful when recording in front of a computer
and studio monitors: you can simply mute the