PRESONUS StudioLive 64S - Page 3

6 The Fat Channel — 43
6.1 Overview — 43
6.1.1 A/B Comparison for EQ
and Dynamics Settings — 44
6.1.2 Copy/Paste & Preset Load/Save — 44
6.2 Fat Channel Navigation — 46
6.3 Input Mode — 48
6.4 Gate Mode (Dynamic Fat Channel) — 50
6.4.1 Dynamic Fat Channel Controls — 50
6.5 Compressor Mode (Dynamic Fat Channel) — 51
6.5.1 Standard Compressor — 51
6.5.2 Tube Leveling Amplifier — 52
6.5.3 Class-A FET Compressor — 53
6.6 EQ Mode (Dynamic Fat Channel) — 54
6.6.1 Standard EQ — 54
6.6.2 Passive Program EQ — 55
6.6.3 Vintage 1970s EQ — 55
6.7 Aux Sends Mode (Dynamic Fat Channel) — 56
6.8 Fat Channel Screens — 57
6.8.1 Channel Overview — 57
6.8.2 Channel Settings Screen — 58
6.8.3 Gate Overview Screen — 59
6.8.4 Compressor Overview Screens — 60
6.8.5 EQ Overview Screens — 63
6.8.6 Aux Sends Overview Screen — 68
6.9 User Mode — 68
6.10 Input Controls — 68
6.10.1 Input Source — 68
6.10.2 Input Meters — 69
6.10.3 Input Source Routing — 69
6.10.4 Polarity and Phantom Power — 71
6.10.5 Stereo Link — 71
6.11 Output Assignment Buttons — 72
6.11.1 Main/Mono Bus Assignment
(StudioLive 64S only) — 72
6.11.2 Main/Subgroup Assignment (All 32-Channel
StudioLive Models) — 72
7 Tape Controls — 73
7.1 Pairing a Bluetooth Device — 73
8 SD Recording — 74
8.1 Creating a New Session for Recording — 74
8.2 Loading a Session for Playback — 75
8.3 Capture Screen — 75
8.3.1 Recording Status Messages — 76
8.3.2 Transport Controls — 77
8.4 Virtual Sound Check — 78
9 Master Control — 79
9.1 StudioLive Series III FLEX DSP Rack Effects — 79
9.1.1 The Effects Editor — 80
9.1.2 Effects Types — 80
9.1.3 Effects Presets — 85
9.4 UCNET — 86
9.4.1 Mixer Nickname — 86
9.4.2 Permissions — 86
9.4.3 Software Control — 87
9.4.4 Control Network IP Address
Settings — 88
9.4.5 Transport Controls — 88
9.5 DAW Button — 89
9.6 Scenes and Projects — 89
9.6.1 Creating and Recalling Projects — 89
9.6.2 Creating and Recalling Scenes — 90
9.6.3 Filters — 92
9.6.4 List Editor — 94
9.6.5 Scene Safe — 95
9.6.6 AutoStore — 95
9.6.6 Reset — 96
9.6.7 Nulling Parameters — 97