Feisty Ferret
Home
Model: # 485 (A)
read first REVIEW BEFORE ASSEMBLY
• TOOLS: Allen wrench (included).
Have needle nose pliers (not included)
o
n hand. If using power tools, be
careful not to over-tighten screws.
For assistance or replacement parts,
please contact Prevue Pet Products:
T
OLL-FREE
8
00.243.3624
ONLINE www.prevuepet.com
EMAIL
customerservice@prevuepet.com
485 (A)—07/15 —USL Made in China for Prevue Pet Products, Inc., Chicago IL USA www.prevuepet.com 800 243-3624 customerservice@prevuepet.com
1
To assemble the BASE, you
will need these pieces:
2
To assemble the first level
CAGE FRONT & BACK
,
you will need these pieces:
3
To assemble the first level
CAGE FLOOR & SIDES
,
you will need these pieces:
× 4 (long)
× 4
Attach the storage shelf to the leg frames with
one long screw in each corner. Note: the
windbell lock on the front leg frame faces out.
Flip unit over and fully insert
casters into frame legs.
× 4 (long)
Guide the lower level front panel (with door)
and back panel into the leg frames as illustrated.
Note: the lower panels have openings at the
top corners.
× 4 (long)
Slide the lower level side panels into place.
Note: the track that will hold the mid-level
floor is at the top and facing in.
Secure the panels with one
long screw in each
bottom corner.
Slide the first floor panel
down into place.
Attach the grille/tray track frames. Secure the
tracks in place with one long screw in each
corner (lower hole). Note: the track
orientation is with the open end
facing the front.
To Next Page
Need help?
General
