42
www.pridemobility.com Colt Series
APPENDIX I - SPECIFICATIONS
COLT /COLT PLUS
Model Number 3-wheel: SC610; 4-wheel: SC710
Class Of Use B
Maximum Safe Slope 14.1% (8°)
Maximum Climbing Ability 14.1% (8°)
Obstacle Climbing Ability 5 cm (2 in.)
Overall Length
2
3-wheel: 115 cm (45.25 in.); 4-wheel: 119.38 cm (47 in.)
Overall Width
2
56.5 cm (22.25 in.)
Total Weight Without Batteries
2,6
3-wheel: 59.65 kg (131.5 lbs.); 4-wheel: 60.1 kg (132.5 lbs.)
Heaviest Piece When Disassembled 3-wheel: Front Section (24.72 kg/54.5 lbs.)
4-wheel: Front Section (27.66 kg/61 lbs.)
Turning Radius
2
3-wheel: 106.68 cm (42 in.); 4-wheel: 137.16 cm (54 in.)
Speed (Maximum)
1
Up to 6.43 km/h (4 mph)
Range Per Charge
1, 4
Up to 25 km (15.5 miles)
Ground Clearance
2
7.62 cm (3 in.) at mid frame
Weight Capacity
158.75 kg, 25 stone (350 lbs.)
Standard Seating Type: Foldable Molded Plastic
Weight: 12.7 kg (28 lbs.)
Material: Black Vinyl
Dimensions: 45.72 cm (18 in.) overall width
43.18 cm (17 in.) effective depth
Drive System Rear-wheel drive, sealed transaxle, 24-volt DC motor
Dual Braking System Regenerative and electromechanical
Tires Front and rear: 25.4 cm (10 in.) solid tires
Battery Requirements
3, 5
Two 12-volt, deep-cycle Size: U1 (31-36 Ah) or optional 40 Ah
Battery Weight: 11 kg (24.5 lbs.) each U1
Battery Weight: 14.74 kg (32.5 lbs.) each 40 Ah
Battery Charger 5-amp, off-board
1
Varies with user weight, terrain type, battery amp-hour (Ah), battery charge, battery condition and tire condition. This specification can be
subject to a variance of (+ or -) 10%.
2
Due to manufacturing tolerances and continual product improvement, this specification can be subject to a variance of (+ or – ) 3 %.
3
AGM or Gel-Cell type required. See V. “Batteries and Charging.”
4
Tested in accordance with ASNI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculation based
on battery specifications and drive system performance. Test conducted at maximum weight capacity.
5
Battery weight may vary based on manufacturer.
6
Includes standard seat.
NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176
series EN12184 standards. All specifications subject to change without notice.
To Next Page
Loading...
