Pride Mobility Zero Turn 10 - Speed and Power Controls

Mid-size Scooter Series 11
EN
II. YOUR SCOOTER
WARNING! Scooter users are required to use their lights when visibility is restricted—day or
night.
Hazard Lights Switch
This switch activates the 4-way fl ashers on your scooter.
To operate hazard lights for models equipped with Tiller Console A and B:
 Toggle the switch forward to turn on the fl ashers.
 Toggle the switch rearward to turn off the fl ashers.
To operate hazard lights for models equipped with Tiller Console C:
 Toggle the switch to the right to turn on the fl ashers.
 Toggle the switch to the left to turn off the fl ashers.
To operate hazard lights for models equipped with Tiller Console D:
 Toggle the switch rearward to activate the fl ashers.
 Return switch to center position to deactivate fl ashers.
Hi-Low Switch
This switch toggles the scooter’s speed between Hi and Low. Toggle the switch forward (Hi) to achieve the
maximum preprogrammed speed for the scooter. Toggle the switch rearward (Low) to achieve half the maximum
preprogrammed speed of the scooter.
Power Seat Switch (If Equipped)
The power seat switch activates the power seat actuator and enables you to raise and lower the seat automatically.
Refer to VI. “Comfort Adjustments” for more information regarding power seat operation and safety.
Throttle Control Lever
This lever allows you to control the forward speed and the reverse speed of your scooter up to the maximum speed
you preset with the speed adjustment dial.
NOTE: The throttle control lever operation instructions outlined below apply to scooters in a standard
confi guration. If the programming of your scooter was modifi ed in any way by a provider, contact that provider
for correct throttle control level operation instructions.
To use throttle control lever for models equipped with Tiller Console A, C, and D:
To move Forward, use either of the following:
 Use your left thumb to push the left side of the throttle control lever.
 Use your right hand fi ngers to pull back on the right side of the throttle control lever.
To move Rearward, use either of the following:
 Use your right thumb to push the right side of the throttle control lever.
 Use your left hand fi ngers to pull backward on the left side of the throttle control lever.
To use throttle control lever for models equipped with Tiller Console B:
 To move Forward, use your right thumb to push the right side of the throttle control lever.
 To move Rearward, use your left thumb to push the left side of the throttle control lever.
Release the throttle control lever and allow your scooter to come to a complete stop before engaging the other side
of the lever. When the throttle control lever is completely released, it automatically returns to the center “stop”
position and engages your scooter’s brakes.