PrimaLuceLab EAGLE3 - Setting exposure and calibration

PrimaLuceLab iSrl EAGLE2 User Manual
3) In the “Connect Equipment” window verify that the “Mount” option is “On-camera”. This option is used when the camera integrates
an ST4 autoguide port. Press “Connect” and then press “Close”. This will close the “Connect Equipment” window.
4) Now select a proper exposition time for the guide camera (usually 1 or 2 seconds) and press the “Looping” button (the one with 2
green arrows). This will start expositions of the guide camera and you will see the image in the preview window.
"
page !46