Maintenance and Troubleshooting 23
3. Feed the supply side of the ribbon under the take up roll.
Tape the supply ribbon to the take-up roll.
4. Manually turn the take-up roll several complete rotatations
to prevent the tape from coming loose.
5. Close the Cover.
F. RETRIEVING A BROKEN OR STUCK SLIDE
If a slide is broken or stuck in the system there are two access
panels that can be used to retrieve the slide. If a slide is found
inside the printer, use the Power and Slide buttons to move the
internal slide rollers forward and back to advance the slide to a
point where it can be removed. Follow this procedure:
1. Open the top cover.
2. Remove the Ribbon.
To Next Page
Loading...
Need help?
General
