Printronix T4M - Table 22. General PTX_SETUP Commands

General Commands
267
CONFIG PANEL LOCK
UNLOCK
This command locks the operator
out of the printer’s configuration
menu.
This command unlocks the printer’s
configuration menu and allows the
operator access to the menus. By
default, the menu is unlocked.
PNE_PORT_NUM Port Number This command sets the Port
Number the PNE uses to
communicate to the printer if the
PNE Port was set to Ethernet. This
command causes the printer to
automatically reboot.
PXML_PORT_NUM Port Number This command sets the Port
Number the PXML and UCP will use
to communicate to the printer if the
PXML Port is set to Ethernet. This
command causes the printer to
automatically reboot.
LP MODE n/a Protocol Protocol must be 0-4. This
command resets the software
protocol, and is selected as follows:
0 - P-Series
1 - P-Series XQ
2 - Serial Matrix
3 - Proprinter III XL
4 - Epson FX-1050
Table 22. General PTX_SETUP Commands
Command Sub-Command Parameter Description