166
The gasket must be inserted correctly into the groove for IP65F moisture resistance
for the GP unit.
4 The upper surface of the gasket should protrude approximately 2.5 mm (0.1 in.)
from the groove. Check the gasket is inserted correctly before installing the GP
unit into a panel.
CAUTION
EQUIPMENT DAMAGE
z Since the gasket is flexible but not elastic, be careful not to stretch it
unnecessarily.
z Make sure the gasket seam is not inserted into any of the GP unit corners.
z Insert the gasket in the installation groove
Failure to follow these instructions can result in injury or equipment damage.
Stage Description
mm
in.
2.5
0.1
To Next Page
Loading...
