Pro-face GP-4401T Replacement Guidebook

3.2 Preparation
PC in which GP-Pro EX Transfer Tool is installed. *2
Requirements for
receiving screen data
from GP/ST-3400
series *1
USB Transfer Cable (model: CA3-USBCB-01)
*Possible to send/receive a screen via a CF card, a USB
storage device, or Ethernet (for GP-3400S only).
PC in which GP-Pro EX Ver.3.01 or later is installed. Requirements for
converting screen
data of GP/ST-3400
series and
transferring the
converted data to
GP-4401T
Transfer Cable (The following three types of cables are
available)
・ A USB transfer cable (model: CA3-USBCB-01)
・ A USB data-transfer cable (model: ZC9USCBMB1)
・ A commercial USB cable (USB Type A/mini B)
*Possible to send/receive a screen via a SD card, a USB
storage device, or Ethernet.
*1: This step is required if screen data is saved only in the GP unit, not in any other device.
*2: Please use the same version or later as or than that of the software used during creating screens on
GP/ST-3400 series. If you don’t know the version, we recommend you to use the newest version. For
the newest version, you can download the transfer tool from our web site called [OtasukePro!]
(http://www.pro-face.com/otasuke/download/freesoft/gpproex_transfer.htm
)
15/40

Pro-face GP-4401T Specifications

General

Brand	Pro-face
Model	GP-4401T
Category	Touch Panel
Language	English