Chapter 5 Appendix
5.1 Changing the setting of the external media to use
If a CF card is used for GP/ST-3400 series, after the display unit type of the project file
is changed to GP-4401T, “a CF card” is automatically replaced with “a SD card” for the
external media setting.
(1) After conversion of the project file data, at GP-Pro EX Error Check,
if the message, “The project contains features that require a SD card. However,
the selected display does not support SD cards so these features will not run.”
appears,
<Cause>
The model without a SD card slot has the setting that uses a SD card.
->Solution 1
(2) To use a USB storage device instead of a SD card ->Solution 1
(3) To check or change the SD card’s data output destination folder setting
->Solution 2
38/40
To Next Page
Loading...
Need help?
General
