Name: Pro-Form 505 CST
Brand: Pro-Form
Rating: 5 (1 reviews)

To Next Page

To Previous Page

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the

ey and UNPLUG THE POWER CORD. If the

walking belt has shifted to the left, use the hex

ey to turn the left idler roller bolt clockwise 1/2 of

a turn; if the walking belt has shifted to the

right, turn the left idler roller bolt counterclockwise

1/2 of a turn. Be careful not to overtighten the

walking belt. Then, plug in the power cord, insert

the key, and run the treadmill for a few minutes.

Repeat until the walking belt is centered.

b. If the walking belt slips when walked on, first re-

move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both idler roller bolts clock-

wise, 1/4 of a turn. When the walking belt is cor-

rectly tightened, you should be able to lift each

edge of the walking belt 2 to 3 in. (5 to 7 cm) off

the walking platform. Be careful to keep the walk-

ing belt centered. Then, plug in the power cord, in-

sert the key, and carefully walk on the treadmill for

a few minutes. Repeat until the walking belt is

properly tightened.

PROBLEM: The console display has lines running through it

SOLUTION: a. If lines appear in the console display, see THE INFORMATION MODE on page 20 and adjust the

contrast level of the display.

Questions and Answers:

Need help?

Do you have a question about the Pro-Form 505 CST and is the answer not in the manual?

Pro-Form 505 CST Specifications

General