EasyManuals Logo

Pro-Form 520x User Manual

Pro-Form 520x
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
TROUBLESHOOTING
Most treadmill problems can be solved by following the simple steps below. Rnd the symptom that
applies, and follow the steps listed. If further assistance is needed, call our toll-free HELPLINE at
1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 8). Use only a single-outletsurge suppressor
that meets all of the specificationsdescdbed on page 8. Important: The treadmill is not compatible
with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key isfully inserted into the console.
c. Check the circuit breaker located on the treadmill
near the power cord. If the switch protrudes as
shown, the circuit breaker has tdpped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
C
Tdpped[_ Reset_
PROBLEM: The power turns off during use
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the
circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord isplugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully intothe console.
d. If the treadmill stillwill not run, please call our toll-free HELPLINE.
PROBLEM: The speed display on the console does not function properly
SOLUTION: a. Remove the key and UNPLUG THE POWER CORD.
Carefully lower the Updghts (64) to the floor, Remove
the three indicated Small Screws (37).
Raise the Updghts (64) to the vertical position. Pivot
the Hood (1) off.
37
23

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pro-Form 520x and is the answer not in the manual?

Pro-Form 520x Specifications

General IconGeneral
BrandPro-Form
Model520x
CategoryTreadmill
LanguageEnglish

Related product manuals