10
HOW TO EXERCISE ON THE ELLIPTICAL
EXERCISER
To mount the elliptical exerciser, hold the handlebars
a
nd step onto the pedal that is in the lowest position.
Then, step onto the other pedal. Push the pedals until
they begin to move with a continuous motion.
Note:
The pedal disks can turn in either direction. It is
recommended that you turn the pedal disks in the
direction shown by the arrow below; however, for
variety, you can turn the pedal disks in the oppo-
site direction.
To dismount the elliptical exerciser, wait until the ped-
als come to a complete stop. Note: The elliptical
exerciser does not have a free wheel; the pedals
will continue to move until the flywheel stops.
When the pedals are stationary, step off the highest
pedal first. Then, step off the lowest pedal.
HOW TO ADJUST THE STRIDE OF THE ELLIPTICAL
EXERCISER
To adjust the stride of the elliptical exerciser, first pull
o
ne of the adjustment knobs until the adjustment
bracket can be pivoted freely. Pivot the adjustment
bracket until the adjustment knob is aligned with either
of the indicated holes in the crank arm, and then gen-
tly release the knob. Pivot the adjustment bracket
back and forth slightly to make sure that the latch pin
is engaged in one of the holes. Adjust the other side of
the elliptical exerciser in the same way.
Pedal
Pedal Disk
Adjustment
Bracket
Adjustment
Knob
Pin
Crank
Arm
Holes
To Next Page
Loading...
Need help?
General
