9
6. Loosen the Seat Knob (29), and then pull it
downward.
Next, insert the Seat Carriage (4) into the Seat
Post (3), and release the Seat Knob (29) into
one of the adjustment holes in the Seat Carriage.
Make sure that the Seat Knob is in an adjust-
ment hole. Then, tighten the Seat Knob.
See the inset drawing. Tighten a #8 x 6mm
Screw (92) into the underside of the Seat
Carriage (4).
6
29
3
4
92
4
7
7. Have a second person hold the Handlebar Post
(6) near the Frame (2).
Locate the long wire tie in the Handlebar Post
(6). Tie the lower end of the long wire tie to the
Main Wire (68).
Next, locate the middle of the long wire tie in the
access hole in the Handlebar Carriage (105).
Pull the long wire tie upward until the end of the
Main Wire (68) is in the access hole.
See the inset drawing. Next, pull the free end
of the long wire tie until the Main Wire (68) is
routed through the Handlebar Carriage (105) as
shown. Then, untie and discard the long wire tie;
do not remove the short wire tie.
105
68
Long
Wire Tie
Avoid
pinching
the Main
Wire (68)
Long Wire Tie
Access
Hole
Pull Here
6
105
2
68
Long
Wire Tie
To Next Page
Loading...
Need help?
General
