To Next PageTo Next PageWhat to do if my Pro-Form Treadmill power does not turn on?
First, ensure the power cord is correctly plugged into a surge suppressor, and the surge suppressor is connected to a grounded outlet. Then, make sure the key is properly inserted into the console. Finally, check the power switch on the treadmill frame; if it's tripped (protrudes), wait five minutes, then press it back in to reset.
What to do if the Pro-Form PFTL73621.0 walking belt slips when walked on?
Remove the key and unplug the power cord. Using the hex key, turn both idler roller screws clockwise, 1/4 of a turn.
What to do if my Pro-Form Treadmill walking belt slows when I walk on it?
If the walking belt is overtightened, treadmill performance may decrease. Remove the key and unplug the power cord. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. It is important to note: never apply silicone spray or other substances to the walking belt or the walking platform unless instructed to do so by an authorized service representative.
How to fix console displays that don't function properly on a Pro-Form PFTL73621.0 Treadmill?
If the console does not boot up properly, or if the console freezes and does not respond, reset the console to the factory default settings.
Why won't my Pro-Form PFTL73621.0 Treadmill connect to the wireless network?
Ensure that the wireless settings on the console are correct and that the settings for your wireless network are also correct.
Why does my Pro-Form PFTL73621.0 power turn off during use?
The power might be turning off during use due to a tripped power switch. Check the power switch and if it has tripped, wait five minutes, and then press the switch back in. Also, make sure the power cord is properly plugged in. If it is, unplug it, wait five minutes, and then plug it back in. Finally, try removing the key from the console and then reinserting it.
How to center the walking belt on my Pro-Form PFTL73621.0?
If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn. If the walking belt has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn.
General| Weight | 203 pounds |
|---|---|
| Motor | 2.75 CHP Mach Z Commercial Pro Motor |
| Running Area | 20 x 60 inches |
| Display | 10-inch HD Touchscreen |
| Folding | Yes |
| Heart Rate Monitoring | EKG Grip Pulse and Bluetooth Chest Strap Compatible |
| Programs | 50+ iFit Coach Programs |
| Speed | 0 – 12 MPH Digital Speed Control |
| Speed Range | 0 – 12 MPH |
