How to turn on Pro-Form PFTL59513.0?
First, ensure the power cord is securely plugged into a surge suppressor, and that the surge suppressor is connected to a properly grounded outlet. Make sure you're using a surge suppressor that meets the necessary specifications. Also, verify that the key is correctly inserted into the console. If the power switch has tripped, wait five minutes, and then press the switch to reset it.
What to do if Pro-Form PFTL59513.0 turns off during use?
If your treadmill turns off unexpectedly, first check that the power cord is properly plugged in. If it is, unplug it, wait five minutes, and then plug it back in. Also, try removing the key from the console and then reinserting it. If the switch has tripped, allow five minutes before pressing it back in to reset it.
How to fix a Pro-Form PFTL59513.0 walking belt that slips?
To correct a walking belt that's off-center or slips, use the hex key. If the belt has shifted left, turn the left idler roller screw clockwise 1/2 turn. If it has shifted right, turn the left idler roller screw counterclockwise 1/2 turn. You can also try turning both idler roller screws clockwise 1/4 of a turn.
What to do if Pro-Form PFTL59513.0 console display doesn't function?
If the console displays are not functioning correctly, remove the key from the console and unplug the power cord. Also, check that the gap between the Magnet and the Reed Switch is about 1/8 inch (3 mm). If needed, loosen the #8 x 3/4" Truss Head Screw, adjust the Reed Switch slightly, and then retighten the Screw.
How to reset incline on Pro-Form PFTL59513.0 Treadmill?
To reset the incline, hold down the Stop button and the Speed increase button, then insert the key into the console, and release both buttons. Alternatively, press the Stop button and then press the Incline increase or decrease button. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.
Why does my Pro-Form PFTL59513.0 walking belt slow down when I walk on it?
The walking belt might slow down if it's overtightened, which can decrease performance and potentially damage the belt. To resolve this, use the hex key to turn both idler roller screws counterclockwise 1/4 of a turn. When the belt is properly tightened, you should be able to lift each edge 2 to 3 inches off the platform. Also, the walking belt may need more lubricant.
How to turn off demo mode on Pro-Form PFTL59513.0?
To turn off demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 21 to turn off the demo mode.
Shows locations of warning decals and instructions for replacement.
Crucial safety guidelines and warnings to reduce risk of injury or property damage.
Step-by-step instructions for assembling the treadmill.
Instructions on connecting the power cord and using a surge suppressor for safe operation.
Step-by-step guide on how to properly start the treadmill, including key insertion.
Guide for operating the treadmill using manual speed and incline controls.
General| Motor | 2.5 CHP |
|---|---|
| Running Area | 20" x 55" |
| Incline | 0-10% |
| Speed | 0-10 mph |
| Display | Backlit |
| iFit | Compatible |
| Weight Capacity | 300 lbs |
| Folding | Yes |
To Next Page