6
5. Remove the backing from the Adhesive Clip (91). Press
the Adhesive Clip onto the Base (70) in the indicated
location. Press the Allen Wrench (92) into the Adhesive
Clip.
91
92
70
5
6. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill. To order a mat, see the back cover of this manual.
4. See HOW TO LOWER THE TREADMILL FOR USE on
page 11. Follow the instructions on page 11 to lower the
treadmill.
Align the hole in the lower end of the right Handrail Arm
(10) with the hole in the frame tab as shown. Attach the
Handrail Arm with a Handrail Bolt (7) and a Handrail Nut
(8).
Repeat this step on the left side.
8
7
Frame Tab
10
4
To Next Page
Loading...
Need help?
General