20
THE INFORMATION MODE
The console features an information mode that keeps
t
rack of treadmill usage information. The information
mode also allows you to select miles or kilometers as
t
he unit of measurement and to turn on and turn off the
display demo mode.
To select the information mode, hold down the Stop
button, insert the key into the console, and then re-
lease the Stop button. When the information mode is
selected, the following information will appear in the
display:
• The number
of hours that
the treadmill
has been op-
erated.
• The total
number of
miles or kilo-
meters that the walking belt has moved.
• An “E” for English miles or an “M” for metric kilome-
ters. To change the unit of measurement, press the
Speed increase button.
• A “d” if the demo mode is turned on. The console
features a display demo mode, designed to be used
if the treadmill is displayed in a store. While the
demo mode is turned on, the console will function
normally when you plug in the power cord, press the
power switch into the reset position, and insert the
key into the console. However, when you remove
the key, the displays will remain lit, although the but-
tons will not function. To turn on or turn off the demo
mode, press the Speed decrease button.
• The word “ON” or “OFF,” indicating the audio setting
for your personal trainer. When you use an iFit card,
a personal trainer will guide you through your work-
o
uts. To turn on or turn off the voice of the personal
trainer, press the Incline decrease button.
To adjust the volume level, press the Incline increase
button.
To exit the information mode, remove the key from the
console.
HOW TO USE THE STEREO SOUND SYSTEM
To play music or audio books through the consoleʼs
stereo speakers, you must connect your MP3 player,
CD player, or other personal audio player to the con-
sole through the audio jack.
To use the audio jack, locate the audio wire and plug it
into the audio jack. Then, plug the audio wire into a
jack on your MP3 player, CD player, or other personal
audio player. Make sure that the audio wire is fully
inserted.
Next, press the Play
button on your MP3
player, CD player, or
other personal audio
player. Adjust the vol-
ume on your personal
audio player or with the
Vol increase and de-
crease buttons on the console. Note: If the volume
cannot be turned up, make sure the volume level is not
set at 0 (see THE INFORMATION MODE on this
page).
If you are using a personal CD player and the CD
skips, set the CD player on the floor or another flat sur-
face instead of on the console.
Volume Decrease
Volume Increase
To Next Page
Loading...
Need help?
General