Note: In cycle mode, if OFF is set to 0, it indicates that the light is usually on, and the light will
not be turned o. In timer mode, if the sta and end times are set, it indicates that the light is usual-
ly on, and the light will not be turned o.
Auto Cycle and Auto Timer lighting data settings:
Manual OFF: manual operation is o, do not enter
the automatic setting.
Auto Timer: You can set the switch and daily cycle.
Up to 10 groups of timers can be set.
Auto Cycle: You can set the rst turn-on time,
turn-on time, and turn-o time.
When the LDA-SPE module is connected, it displays
the intensity settings of the 4 light channels and the
total intensity settings；
Single light intensity = CH-X (1-4) single intensity *
total intensity (POWER OUTPUT).
Automatic temperature adjustment: When the temperature exceeds the set value, the lamp
will automatically adjust to half the output of the set value, if it is lower than 40% after adjust-
ment, it will be set to 40%.
Shutdown temperature: When the temperature exceeds the set value, it will automatically
shut down.
Sunset Control: Simulates the duration of sunrise and sunset.
A.
B.
C.
A
B
C
LIGHT
Click [LIGHT] to enter the light settings:
17
To Next Page
Loading...