6. Check the fuel level.
7
. Reinsert the fuel tank cap and tighten.
8. Wipe up any spilled fuel before starting the engine or allow to
evaporate. Spilled fuel is both a fire hazard and an environmental
hazard. Dispose of the fuel soaked rags in a proper hazardous
waste container.
ENGINE OIL
NOTICE! Non-detergent and 2-stroke engine oils will
damag
e a 4-stroke engine and are not recommended.
1. Check the oil level before each use with a cool engine that is level.
2. Use 4-stroke motor oil that meets or exceeds the requirements for
the API (American Petroleum Institute) service classification (see
Specifications).
3. Do not use special additives.
4. SAE 10W-30 is recommended for general,
all-temperature use. Other viscosities
shown on the chart may be used when
the average temperature in your area is
within the indicated range.
5. Using 10W-30 oil when the temperature
is above 27°C (80°F) may increase oil
consumption . Check the oil level more
often.
6. Starting the engine will be more difficult
when using SAE 30 oil below 4°C (40°F).
HOW TO CHECK OIL
1
. Level the engine or the equipment the engine is mounted on.
2. Remove the Oil Maintenance Cover to access the oil dipstick.
3. Clean the oil fill area of any dirt and debris to prevent
contamination that can damage the engine.
Figure 2
.
8953168 GASOLINE GENERATOR WITH ELECTRIC START V1.1
Assistance available at www.princessauto.com or 1-800-665-8685 Page 18
To Next Page
Loading...