The following instructions must be followed in order to keep the
emissions from your engine within Canadian emission standards.
1. Do not remove or alter any part of the intake, fuel or exhaust
system.
2. Do not alter or bypass the governor linkage or a speed-adjusting
mechanism that force the engine to operate outside its design
specifications.
PROBLEMS THAT MAY AFFECT EMISSIONS
Have your engine inspected and repaired by a qualified technician if
you are aware of any of the following symptoms.
1. Hard starting or stalling after starting.
2. Rough idle.
3. Misfiring or backfiring under load.
4. Afterburning (backfiring).
5. Black exhaust smoke or high fuel consumption.
REPLACEMENT PARTS
The emission control systems on the engine is designed, built and
certified to conform to Canadian emission regulations. Genuine parts
are recommended when servicing the engine. Genuine replacement
parts are manufactured to the same standards as the original parts.
Using replacement parts that are not of the original design and quality
may impair the effectiveness of the emission control system.
It is the responsibility of the aftermarket part manufacturer to certify that
the part will not result in a failure of the engine to comply with emission
regulations.
REPLACING THE SPARK PLUG
NOTICE! Using an incorrect spark plug can cause
engine damage. Only replace a spark plug with a model
recommended by the manufacturer.
The spark plug must be properly gapped and free of deposits for the
best performance. Check local bylaws to see if a resistor spark plug is
required to suppress ignition signals. Replace the included spark plug
with a resistor spark plug if required.
1. Remove the Spark Plug Cover and set aside.
8953168
GASOLINE GENERATOR WITH ELECTRIC START V1.1
Assistance available at www.princessauto.com or 1-800-665-8685 Page 22
To Next Page
Loading...