ProgrammingProgramming
Programming Programming
Set Time
1. Press TIME
2. Day of the week will be ashing. Use the or key
to select the current day of the week.
3. Press PROGRAM
4. The current hour is ashing. Use the or key to
select the current hour. When using 12-hour time, make sure
the correct a.m. or p.m. choice is selected.
5. Press PROGRAM
6. Minutes are now ashing. Use the or key to
select current minutes.
8. Press the TIME button in order to go back a step.
7. Press HOLD/RUN when completed.
Programming
All of our programmable thermostats are shipped with an
energy saving pre-program. You can customize this default
program by following the steps on page 14.
Your thermostat can be programmed to have all the weekdays
the same, a seperate program for Saturday, and a seperate
program for Sunday. There are four time periods for each
program (WAKE, LEAVE, RETURN, SLEEP).
Set Program Schedule
1. Select HEAT or COOL with the system switch. Note: You have
to program heat and cool each seperately.
2. Press the PROGRAM
3. Monday-Friday is displayed and WAKE is shown. You are now
programming the wake time period for the weekday setting.
4. Time is ashing. Use the or key to make your time
selection for the weekday WAKE time period.
5. Press PROGRAM
6. The setpoint temperature is ashing. Use the or key
to make your setpoint selection for the weekday wake period.
7. Press PROGRAM
8. Repeat steps 4 thru 7 for weekday LEAVE time period, for
weekday RETURN time period, and for weekday SLEEP time
period.
To customize your program schedule, follow these steps
Weekday:
Repeat steps 4 thru 7 for the Saturday WAKE time period, LEAVE
time period, RETURN time period, and for the Saturday SLEEP
time period.
Saturday:
Repeat steps 4 thru 7 for the Sunday WAKE time period, LEAVE
time period, RETURN time period, and for the Sunday SLEEP
time period.
Sunday:
You can use the table below to plan your customized program schedule.
If using 7-Day Programming use previous steps for
every individual day.
To Previous Page