Process Sensors MCT 300 - Page 29

Moisture = 12.89%
MCT200 V3.39E
Moisture = 12.89%
New Password: 0
000
Moisture = 12.89%
Set Clean Window
Software Version
The revision of the Eprom is stored for
reference.
Password Change:
The password that is needed to gain access
to other menu selections may be customized.
The default password is 0000. The display
will default to this default value even if the
password has been set to a different number.
To change the password move the cursor
under the digit and scroll up/down to set a
new number. If the password is not known or
forgotten consult Process Sensors for a
special number to gain access to
Miscellaneous. Enter this special password
and then Enter a new password as above.
The characters that may be used in the
password are 0-9.
The MCT series sensors arre fitted with
software that continually monitors the
cleanliness of the sensor window. This
software may be switched ON/OFF by this
command. More details of this "Dirty Window
Alarm" are found in the Accessories section
of the manual.
Reset Software:
Pressing the ENTER key will reset the
software.
Moisture = 12.89%
Enter for Reset
26