M-62-04 SHC-1.4-61RQH-R-0070 Manual
Revision - Date: 02 – 09/23/2015
4
INTRODUCTION (CONTINUED):
Chemical Compatibility:
Although fluoropolymer is resistant to most chemicals, there are some process chemistries
with which the inline heater should not be used. These may include the following:
Chemicals that degrade or decompose when heated.
Chemicals that are flammable, explosive, or produce dangerous or irritating vapors
when heated (Consult Process Technology).
Halogenated solvents which attack the fluoropolymer material.
Do not use the SHC in line heater to heat
incompatible chemistries. Incompatible materials
will cause corrosion of the underlying stainless
steel components, which may result in a heater
failure.
The Process Technology SHC heater heats
process fluid to temperatures as high as 80
C.
However, the over-temperature protection circuit
will allow the heater core to reach temperatures
as high as 83
C. Consult the factory BEFORE
attempting to heat flammable or combustible
fluids.
To Next Page