5. Clean Around the Head: It's important to clean around the head for any build-up inks at the end
of every day. Build-up inks can get on to the print head from the wiper and can potentially
damage the print head. DO NOT USE ALCOHOL.
6. Clean Wiper Blade: Same as cleaning around the head, making sure the wiper blade is
cleaned. It is very important to obtain a good nozzle check. Any residue buildup can damage the
print head and your head cleaning may not be effective. DO NOT USE ALCOHOL.
7. Clean Capping Station Cap Top: Keeping the capping station cap tops clean is one of the
most important tasks.Your head cleaning may not be effective.Your printer may not draw out the
proper amount of ink if there are a lot of build-up inks. DO NOT USE ALCOHOL.
8. Flush Capping Station Cap with Cleaning Solution: Fill cleaning solution on the cap after the
end of the day maintenance and press the clean button to flush out the cap immediately.This will
ensure the print head is sitting on the cap. DO NOT USE ALCOHOL.
9.
Regularly check whether the ink sac is broken or leakage of ink occurs, if so, please replace
the ink sac in a timely manner to avoid ink
leakage to the print head
,
causing the print head
to
burn out.
10. Empty Waste Tank: Regularly check the waste ink bottle. Waste ink will overflow resulting in a dirty
work surface, Please ensure that the waste ink lines are not touching the waste ink.It may cause
negative pressure, which can cause the waste ink to reverse the ink discharge resulting in the print
head, circuit board into the ink, damage to the print head, the motherboard and other components.
11. Clean Pinch Rollers: Clean pinch rollers ensure that you have a consistent pull on the film.Film
residues can make the roller miss the turns which can cause misalignment on the White and
CMYK heads.Use a dry microfiber cloth or lint-free wipe to clean the rollers. Weekly-clean one
side, As you replace the film to new, clean 360 degrees.
12. Clean Encoder Strip: The encoder strip can be cleaned with isopropyl alcohol, simply wipe
both sides/check for any dents or ink splash.
13. Grease Carriage Rail: If you hear squeaky noise,it's time to grease the rails.Use heat-resistant
gel/paste-based grease. DO NOT USE A SPRAYER.
14. Rinse the Ink Containers: Ink can settle inside the container, please contact with Procolored
tech staff before performing this task.
To Next Page
Loading...
