12 PLG029b
ENGLISH
OPERATING INSTRUCTIONS
1. Start by lling half the quantity of gasoline required into a clean approved petrol
container.
2. Add the entire oil quantity.
3. Close container and mix (shake) the fuel mixture.
4. Add the remaining quantity of gasoline.
5. Remix (shake) the fuel mixture carefully before lling the unit’s fuel tank.
6. Replace fuel container cap and wipe any spilled fuel from the container and
surrounding area.
FILLING TANK
WARNING: Always shut off engine before fueling. Never add fuel to a machine
with a running or hot engine.
1. Clean surface around fuel cap to prevent contamination.
2. Loosen fuel cap slowly. Rest the cap on a clean surface.
3. Carefully pour fuel into the fuel tank. Do not ll fuel tank more than 80% of tank
capacity.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace fuel cap and hand tighten. Wipe up any fuel spillage
Starting and Stopping
WARNING!
Move at least 9 m (30 ft.) from refueling site before starting engine.
Do not smoke! Do not allow open ame near the brush cutter or fuel.
Trimmer should be on a at, bare surface for starting.
1. Set the ignition switch (G, g.17) to “I”: START.
2. Slowly press the primer bulb 6 - 8 times (g.18), until the gas/oil mixture ows in
and out of the discharge hose above the fuel tank..
n
n
To Next Page
Loading...