v.080131 5
ENGLISH
1. After engine stops, allow the blade to keep rotating in thicker weeds or pulpy
stalks until it stops.
2. Do not operate the brush cutter unless the brush cutter guard is rmly secured
in place and in good condition.
3. Use heavy gloves when operating the brush cutter and when installing or
removing blades.
4. Always stop the engine and remove the spark plug wire before attempting to
remove any obstruction caught or jammed in the blade or before removing and
installing the blade.
5. Do not attempt to touch or stop the blade when it is rotating.
6. A coasting blade can cause injury while it continues to spin after the engine is
stopped or throttle trigger released. Maintain proper control until the blade has
completely stopped rotating.
7. Replace any blade that has been damaged. Always make sure blade is installed
correctly and securely fastened before each use. Failure to do so can cause
serious injury.
8. Use only the manufacturer’s replacement blade intended for use on this brush
cutter. Do not use any other blade. Installing any other brand blade or cutting
head to this brush cutter can result in serious personal injury.
9. The blade is suited for cutting thicker weeds or pulpy stalks only. Do not use for
any other purpose.
10. Never use the blade to cut woody brush.
11. Never cut any material over 13 mm (1/2 in.) diameter.
12. Always wear the shoulder harness when using the brush cutter and adjust to
a comfortable operating position. Maintain a rm grip on both handles while
cutting with a blade. Keep the blade away from body and below waist level.
13. Never use the brush cutter with the blade located 75 cm (30 in.) or more above
ground level.
ADDITIONAL SAFETY RULES FOR LINE TRIMMER USE
ADDITIONAL SAFETY RULES FOR BRUSH CUTTER AND BLADE USE
1. Replace line head if cracked, chipped, or damaged in any way. Be sure the line
head is properly installed and securely fastened. Failure to do so can cause
serious injury.
2. Make sure all guards, straps, and handles are properly and securely attached.
3. Use only the correct size replacement line in the cutting head. Do not use any
other cutting attachment. To install any other brand of cutting head to this line
trimmer can result in serious personal injury.
4. Never operate unit without the grass guard in place and in good condition.
5. Maintain a rm grip on both handles while trimming. Keep line head below waist
level. Never cut with the line head located over 75 cm (30 in.) or more above
the ground.
SPECIFICATIONS
Model PLG029b
Dry weight 6.1 kg (13.42 lb.)
Engine Single cylinder 2-stroke engine
Engine displacement 30 cc
Fuel/Oil mix ratio 40:1
Ignition Electronic
Spark plug Torch L8RTC
Engine performance max. 1.0 kW / 7500-8000 rpm
Fuel tank capacity 600 ml (0.16 US gal.)
Drive shaft length 180 cm (71”)
Steel cutter blade 230 mm (9”) diam. x 1.6 mm (1/16”) x 4
teeth
Line trimmer cutting diam. 430 mm (16.9”)
Line diameter 2 mm (0.079”)
To Next Page
Loading...