Prodigit 3354F - Table 4-10 Register of PROT Status

3350F Series Operation Manual 91
[STATe
：
] PROTect
？
Syntax： [ STATe：] PROTect？{；NL}
Purpose：Query if there have protection flag which had been set in this 3350F
Description：1.PROT? means the status of Protection of 3350F. “1” means OPP
occurred.”4”means OVP. “8” means OCP. Table 4-10 shows the
corresponding number of protection status
2.Use command CLR to clear the register of PROT status to be “0”
Table 4-10 register of PROT status
[STATe
：
] CCR {AUTOR2}
Syntax： [STATe：] CCR {AUTOR2}{；NL}
Purpose：Set the CC MODE RANGE to be forced to switch to RANGE II
Description：It will switch the RANGE position automatically when setting for AUTO Set
R2 when implementing RANGE II
[STATe
：
] NGEABLE {ONOFF}
Syntax： [STATe：] NGEABLE {ONOFF} {；NL}
Purpose：To set the GO/NG check function enable or disable.
Description：To set the function of NG judgment opens when POWER ON. When
setting for POWER OFF, the function of NG judgment will not be
implemented.
[STATe
：
] POLAR {POSNEG}
Syntax： [STATe：] POLAR {POSNEG} {；NL}
Purpose：Set for the display of the voltage meter shows the pole is contrary or not
Description：Set the display of the voltage meter shows the pole. If it shows POS, that
means the pole is not contrary. If the pole is contrary , it will show NEG
[STATe
：
] START
Syntax： [STATe：]START {；NL}
Purpose：Set for Load to implement the test.
Description ： Set for Load to implement the test , and according to TEST
CONFIG(TCONFIG) , the Load will start to test the items and
parameters which are required
[STATe
：
] STOP
Syntax： [STATe：]STOP {；NL}
Purpose：Set for Load to stop the test
7
6 5
4
3
2
1
0
Over Current Protection (OPP)
Over Voltage Protection (OVP)
Over Current Pttion (OCP)
bit 7
bit 0
Over Temperature Protection (OTP)