Prodys QUANTUM LITE - IV.2.1.7. Streaming Protocol Selection (MPEG-TS); IV.2.1.8. Streaming TX Parameters (BRAVE)

Prodys S.L. Tel: +34 91 6896880  Fax: +34 91 6943777  Email: sales@prodys.net  Web: www.prodys.com
Page 43
IV.2.1.7. Streaming Protocol selection (MPEG-TS)
When MPEG-TS protocol is selected, this menu is used to set some MPEG-TS
parameters. These parameters are:
 Speed of the Transport Stream.
 Local port. Its default value is 1234.
 Transport Stream ID.
 PMT PID.
 Video PID.
 Audio1 PID.
NOTE: Quantum streams audio data encapsulated in MpegTS format
over UDP protocol. Please check that the remote codec support
MpegTS over UDP.
IV.2.1.8. Streaming TX parameters (BRAVE)
This menu allows the user to choose between Bonding and Diversity types when
working with BRAVE protocol. Independent configuration variables are available
for PROGRAM and TALKBACK channels.
 Bonding: it consists of the bandwidth aggregation of all the transmission
interfaces available at that moment. The traffic is sent using a dynamic
load balance algorithm.