8
CONFIGURAZIONI CONSIGLIATE
SUGGESTED CONFIGURATIONS
MODELLI PASSIVI
PASSIVE MODELS
NEOS
amplifier model
amplifier output
CH 1 CH 2 MODE CH 1 CH 2 MODE CH 1 CH 2 MODE CH 3 CH 4 MODE CH 1 CH 2 MODE CH 3 CH 4 MODE CH 1 CH 2 MODE
1 1S 11S11S
2 2S 22S22S
11S 11S11S
22S22S22S22S
1 1S 11S11S
2 2S22S22S22S
B* B* B* 1 1 S*
2 2S*
B* B* B* 1 1 S*
22S*
P** P** 1**** 1**** S*
speaker model
Legend
S stereo mode
B bridge mode
P parallel mode
* the use of a speaker processor like PROEL DSO480 is highly recommended to set properly limiters and xover frequencies
** all HPD amplifiers have a LOW PASS and HIGH PASS filter centered at 100Hz, this is a compromise for the most used crossover frequency between
sub and sat but if a more precise control is required, the use of a speaker processor like PROEL ASO25 or DSO480 is highly recommended.
*** this configuration require a 4 poles cable
**** this configuration require a special 4 poles patch cable see below
The more complex configurations like BI-AMP and ARRAY are not considered on this sheet,
these configuration require the use of a DSO 480 properly set, contact PROEL directly for further information.
CONFIGURAZIONI CONSIGLIATE Italiano
SUGGESTED CONFIGURATIONS English
2+
1+
1-
2-
AMPLIFIER SIDE
LATO AMPLIFICATORE
DUAL CONE SUBWOOFER SIDE
LATO SUBWOOFER DOPPIO CONO
NOTE: remove the screws 1+ and 1- , insert the wires in the holes then sold them.
NOTA: rimuovere le viti 1+ e 1-, inserire i fili nei fori e saldarli.
25mm
25mm
0.9"
0.9"
8mm
8mm
0.3"
0.3"
RED
RED
BLACK
BLACK
2
+
1+
1-
2-
NEOS215SP, NEOS218SP: connection with 4 poles cable from single output (HP-D3400)
NEOS215SP, NEOS218SP: connessione con cavo 4 poli da uscita singola (HP-D3400)
Proelcode: NL4FX
Proelcode: NL4FX
Proelcode: HPC640
To Next Page
Loading...
Need help?
General
