To Next PageTo Next Page
What to do if my ProForm 620 Zlt Treadmill turns off during use?
If your ProForm Treadmill's power turns off during use, there are a few things you can check. First, examine the power switch; if it has tripped, wait five minutes before pressing it back in. Next, ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, and then plug it back in. Finally, try removing and reinserting the key from the console.
How to fix a ProForm 620 Zlt that does not turn on?
If your ProForm Treadmill doesn't turn on, ensure the power cord is plugged into a properly earthed outlet and that the key is inserted into the console. Also, check the switch; if it protrudes, wait five minutes before pressing it back in.
What to do if ProForm 620 Zlt Treadmill walking belt slips?
If the walking belt on your ProForm Treadmill slips when you walk on it, remove the key and unplug the power cord. Then, using a hex key, turn both idler roller screws clockwise a quarter of a turn.
How to reset incline on ProForm Treadmill?
If the incline of your ProForm Treadmill does not change correctly, hold down the Stop button and the Speed increase button, insert the key into the console, and then release the buttons. Press the Stop button and then press the Incline increase or decrease button.
Why does my ProForm Treadmill walking belt slow down when I walk on it?
If the walking belt on your ProForm Treadmill slows down when you walk on it, and it feels overtightened, remove the key and unplug the power cord. Turn both idler roller screws counterclockwise by a quarter of a turn. Important: Do not apply silicone spray or other substances to the walking belt or platform unless specifically instructed.
How to troubleshoot ProForm 620 Zlt Treadmill console display issues?
If the displays of your ProForm Treadmill console are not functioning correctly, first remove the key from the console and unplug the power cord. Then, carefully lift the motor hood, slide it forward, and remove it. Ensure the gap between the magnet and the reed switch is about 1/8 inch (3 mm). If needed, loosen the truss head screw and adjust the reed switch slightly.
How to turn off demo mode on ProForm 620 Zlt Treadmill?
If the console displays on your ProForm Treadmill remain lit after removing the key, the demo mode is likely turned on. To disable demo mode, press and hold the Stop button for a few seconds.
General| Motor | 2.5 HP |
|---|---|
| Running Area | 20" x 55" |
| Display | LCD |
| Programs | 18 |
| Weight Capacity | 250 lbs |
| Folding | Yes |
| Incline | 0-10% |
| Speed | 0-10 mph |
| Heart Rate Monitoring | Yes |
| Speed Range | 0-10 mph |
| Incline Range | 0-10% |
