CONSOLE DIAGRAM
HIGH
AI--"--
Low
PRO'FORM
TIME / DISTANCE CALS / F-CALS / SPEED
ON / RESET
Note: If there is a thin sheet of clear
plastic on the face of the console,
remove it before operating the console.
AEROBIC
FAT BURN
Battery
Cover Tab
8
BATTERY INSTALLATION
The console requires two "AA" batteries (not in-
cluded). Alkaline batteries are recommended. Open
the battery cover as shown in the drawing at the upper
right. Insert two batteries into the battery compartment,
making sure that the negative (-) ends of the batteries
are touching the springs in the battery compartment.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Be sure that the tab locks into place.
STEP-BY-STEP CONSOLE OPERATION
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot
rails of the treadmill. Find
the clip attached to the key,
and slide the clip onto the
waistband of your clothing.
Follow the steps on page 9 to operate the console.
To Next Page
Loading...
Need help?
General