7
7. Attach the two Wheels (94) to the base of the Uprights
(97) with two Wheel Bolts (90), four Wheel Spacers (79),
and two Nuts (20) as shown. Do not overtighten the
Nuts; the Wheels should turn freely.
With the help of a second person, carefully raise the
Uprights (97) to the vertical position.
79
94
79
97
94
79
90
20
79
90
7
8. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the
walking belt (see page 23). To protect the floor or carpet, place a mat under the treadmill.
6. Attach the four Base Pads (99) to the base of the
Uprights (97) with four Base Pad Screws (40) in the loca-
tions shown.
40
97
99
99
40
99
40
40
99
6
20
5
5 Lower the treadmill Frame (59) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21). With the help
o
f a second person, carefully tip the Uprights (97) down
as shown.
Firmly tighten the two Nuts (20) on the 3” Bolts (86).
97
20
2
0
59
8
6
To Next Page
Loading...
