RESULT
The boot up of the Gateway takes around 2min until
the LED 1 lights up green. The connectivity device is
connected to the end device.
2. Plug the other end of the
USB cable into the Micro USB
socket of the Gateway. A
clear clicking sound confirms
the correct fastening.
4. Connect with the COM port on the end device.
RESULT
The boot up of the Gateway takes around 2min until
the LED 1 lights up green. The connectivity device is
connected to the end device.
3
RD
STEP: SWITCH ON THE SCANNER
1. Position scanner on the
fastening rail of the wearable.
The pins face down.
2. Push scanner down. A clear
clicking sound confirms the
correct fastening.
3. Press the textile trigger on
the glove for about 2 seconds
RESULT
Scanner lights up with all LEDs. You can hear a beeping
sound and feel a short vibration.
Scanner is switched on.
NOTE
Scanner switches off automatically after 15 minutes
without being used.
To Next Page
Loading...
