EasyManuals Logo

Projecta IC2500 User Manual

Projecta IC2500
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
21
FREQUENTLY ASKED QUESTIONS
Q. How do I know if the battery is charged?
A.Thecharger’sFULLYCHARGEDLEDwillilluminate(solid)andtheremote’sbi-colour
LEDwillilluminategreen(solid).AlternativelyuseaBatteryHydrometer(ProjectaPart
No.BH100).Areadingof1.250ormoreineachcellindicatesafullychargedbattery.
Q. I have connected the charger properly but the LCD display reads 0.0 (zero)
Volts and does not appear to be charging.
A.Insomecasesbatteriescanbeflattenedtothepointwheretheyhaveverylittleorno
voltage.Thiscanoccurifasmallamountofpowerisusedforalongtime,forexample
amapreadinglightisleftonforaweekormore.Projecta7Stagechargersare
designedtochargefromaslittleasaslittleas2.5Volts(12V)or4.5Volts(24V).
Ifthevoltageislowerthanthevoltagesstatedaboveuseapairofboostercables
toconnectbetweentwobatteriestoprovidemorethan2.5Volts(12V)or4.5Volts
(24V)tothebatterybeingcharged.Thechargercanthenstarttochargethebattery
andtheboostercablescanberemoved.
Q. Can I use the charger as a power supply
A.PowerSupplymodeisdesignedtooperateasafloatchargetomaintainabattery
whenrunningaloadorappliancefromthebattery.PowerSupplywillonlyoperate
whenconnectedtoabattery.
Q. How can I tell what stage the battery charger is in?
A.TheLCDscreenandcolouredLEDsindicatethevariousstagesofcharging.Refer
topages7(“LEDChargeIndicators”)and13(“ChargingInstructions–Step7”)
of this booklet.
Q. What happens if my battery charger is in Desulphation mode or Soft Start
mode, but I want to start bulk charging?
A.Desulphationmodeistimelimitedto6hoursandSoftStartislimitedto1hour.Ifyou
cannotwaitforthebatterychargertomovethroughthesestagesyoucanselectPower
Supplymodetochargethebattery.AfteranhourofcharginginPowerSupplymode,
thereshouldbesufficientchargeinthebatterytobypassbothDesulphationandSoft
Start. Select the correct battery chemistry type to continue charging the battery. Whilst
inPowerSupplymodethechargerwilloutputafullcurrentupto13.8Volts(12V)or
27.6Volts(24V).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Projecta IC2500 and is the answer not in the manual?

Projecta IC2500 Specifications

General IconGeneral
BrandProjecta
ModelIC2500
CategoryBattery Charger
LanguageEnglish

Related product manuals