ProLights Diamond19 - Lamp Settings

23
DIAMOND19
3.16 WIRELESS CONTROL SETTINGS
To enable wireless control mode, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Connect icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select Wireless DMX and press ENTER.
• Press the UP/DOWN and LEFT/RIGHT buttons to select the desired value (001-512).
• Press the ENTER key to conrm the setting.
To change the settings of wireless control, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select Wireless Set, and press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to select the option proposed and press the ENTER button to conrm your
choice.
- DMX On Cable - Disable/enable the DMX signal cable. Select OFF to deactivate or ON to activate the
function.
- Reset Connect - Reset the wireless connection of the unit. Select OFF to deactivate or ON to activate
the function.
• Press the ENTER button to conrm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
3.17 FIXTURE SETTINGS
You can change the parameters for the device by following these steps:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Set icon, then press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, then select Movement and press the ENTER but-
ton to enter the next menu.
• Use the UP/DOWN button to select the option proposed and press the ENTER button to conrm the
setting.
- Pan Reverse - Pan rotation in the opposite direction. Select OFF to deactivate the function (normal
setting); ON to activate the function (Pan Reverse).
- Tilt Reverse - Used for reversing tilt movement. Select OFF to deactivate the function (normal setting);
ON to activate the function (Tilt Reverse).
- Pan Degree - Angle of Pan. Select 540° or 630° to set the maximum angle of rotation of the moving
head.
- Encoders - Reorganization Pan/Tilt position after rolling away. Select OFF to deactivate or ON to ac-
tivate the function.
- Pan/Tilt Mode - Type of movement of the moving head. Select Standard to obtain a fast and uid
movement of Pan/Tilt, Smooth for a slower and softer movement of Pan/Tilt.
• Press the ENTER button to conrm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
3.18 LAMP SETTINGS
You can change the parameters of the device lamp by following these steps:
• Press the ENTER button to access the main menu.