What to do if ProLights Diamond19 Flood Light fixture does not light up?
If your ProLights Flood Light fixture doesn't light up, there are several potential causes. First, ensure the power supply voltage is correct. If the power is on, check that the dimmer and color faders are not set to 0; increase their values. If the issue persists, a faulty LED or LED board may be the cause, requiring replacement.
Why ProLights Diamond19 fixture does not power up?
If your ProLights Flood Light fixture isn't powering up, the issue could stem from a few sources. First, verify that the power outlet is active. Next, inspect the power cord for any signs of damage or looseness. If both are fine, the internal power supply might be faulty and require replacement.
General| Luminous Flux | 10'000 lm |
|---|---|
| Beam Angle | 4° - 60° |
| IP Rating | IP20 |
| Power Consumption | 320W@230V |
| Frequency | 50/60 Hz |
| Material | Aluminum |
| Control Protocol | DMX, RDM |
| Control | DMX |
| CRI | >80 |
| Input Voltage | 100-240V AC |
| Lifespan | 50000 hours |
To Next Page